糖肽的固相合成

目前糖肽的固相合成可以分为两种策略：构建单元策略和固相糖基化策略。本文对O-连接和N-连接糖肽固相合成的研究进展进行了综述。     

固相微萃取研究进展

对固相微萃取的发展背景，应用及其研究进展作了综述。引用文献 145篇。     

Epoxidation and oxidation reactions using 1,4-butanediol dimethacrylate crosslinked polystyrene-supported tertiary butyl hydroperoxide

1,4-Butanediol dimethacrylate (1,4-BDDMA) crosslinked polystyrene-supported t-butyl hydroperoxide was employed in the epoxidation of olefins and oxidation of alcohols to carbonyl compounds. The reagent proved to be successful as a recyclable solid phase organic reagent with as much or more efficiency when compared to its monomeric counterpart. The extent of reaction was found to be dependent on various reaction parameters like solvent, temperature, molar concentration and presence of catalyst.     

Sensitive trace enrichment of environmental andiandrogen vinclozolin from natural waters and sediment samples using hollow-fiber liquid-phase microextraction

The presence of vinclozolin in the environment as far as the endocrine disruption effects in biota are concerned has raised interest in the environmental fate of this compound. In this respect, the present study attempts to investigate the feasibility of applying a novel quantitative method, liquid-phase microextraction (LPME), so as to determine this environmental andiandrogen in environmental samples such as water and sediment samples. The technique involved the use of a small amount (3 microL) of organic solvent impregnated in a hollow fiber membrane, which was attached to the needle of a conventional GC syringe. The extracted samples were analyzed by gas chromatography coupled with electron-capture detection. Experimental LPME conditions such as extraction solvent, stirring rate, content of NaCl and pH were tested. Once LPME was optimized, the performance of the proposed technique was evaluated for the determination of vinclozolin in different types of natural water samples. The recovery of spiked water samples was from 80 to 99%. The procedure was adequate for quantification of vinclozolin in waters at levels of 0.010 to 50 microg/L (r> 0.994) with a detection limit of 0.001 microg/L (S/N= 3). Natural sediment samples from the Aliakmonas River area (Macedonia, Greece) spiked with the target andiandrogen compound were liquid-liquid extracted and analyzed by the methodology developed in this work. No significant interferences from the samples matrix were noticed, indicating that the reported methodology is an innovative tactic for sample preparation in sediment analysis, with a considerable improvement in the achieved detection limits. The results demonstrated that apart from analyte enrichment, the proposed LPME procedure also serves as clean-up method and could be successfully performed to determine trace amounts of vinclozolin in water and sediment samples.     

Rapid determination of panaxynol in a traditional Chinese medicine of Saposhnikovia divaricata by pressurized hot water extraction followed by liquid-phase microextraction and gas chromatography-mass spectrometry

Panaxynol is a bioactive component in traditional Chinese medicines (TCMs), such as Saposhnikovia divaricata and Panax ginseng. In the work, two solvent-free sample techniques of pressurized hot water extraction (PHWE) and headspace liquid-phase microextraction (HS-LPME) were combined and developed for the determination of panaxynol in a TCM of S. divaricata. Panaxynol in the TCM samples from different growing areas was extracted by PHWE in dynamic mode, followed by extraction and concentration with HS-LPME and analysis with gas chromatography-mass spectrometry (GC-MS). The PHWE and HS-LPME parameters were optimized and the method validations were studied. Panaxynol in S. divaricata from four different growing areas was quantitatively analyzed by internal standard method. These results have shown that PHWE-LPME-GC-MS is a simple, rapid, efficient and low-cost method for the determination of panaxynol in TCMs and is a potential tool for TCM quality assessment.     

顶空固相微萃取-气相色谱-质谱法测定废水中痕量挥发性烷基硫化物

建立了顶空固相微萃取(HS-SPME)和气相色谱/质谱(GC/MS)联用测定人工湿地废水中的痕量挥发性烷基硫化物的方法。针对废水中两种主要的挥发性烷基硫化物(二甲基硫、二甲基二硫),详细研究了萃取纤维头的种类、萃取时间、萃取温度、pH值、离子强度、样品量及解析条件对HS-SPME的影响。载气为高纯氦气,流速为1.0mL/min,色谱柱为DB-5ms毛细管柱(0.25μm,30m×0.32mm),柱温:25℃(5min)■40℃(1min)■60℃(5min);在优化的实验条件下,本法测定二甲基硫及二甲基二硫的线性范围分别为10～10000ng/L和1～10000ng/L;检出限(3σ)分别为1.9ng/L和1.8ng/L;相对标准偏差小于10%;回收率分别为81.0%～94.6%和84.0%～100.9%。用二乙基硫为内标物质,将本法用于人工湿地废水中主要的烷基硫化物二甲基硫和二甲基二硫的测定,获得满意结果。     

Feasibility of a liquid-phase microextraction sample clean-up and liquid chromatographic/mass spectrometric screening method for selected anabolic steroid glucuronides in biological samples

Anabolic androgenic steroids (AAS) are metabolized extensively in the human body, resulting mainly in the formation of glucuronide conjugates. Current detection methods for AAS are based on gas chromatographic/mass spectrometric (GC/MS) analysis of the hydrolyzed steroid aglycones. These analyses require laborious sample preparation steps and are therefore time consuming. Our interest was to develop a rapid and straightforward method for intact steroid glucuronides in biological samples, using liquid-phase microextraction (LPME) sample clean-up and concentration method combined with liquid chromatographic/tandem mass spectrometric (LC/MS/MS) analysis. The applicability of LPME was optimized for 13 steroid glucuronides, and compared with conventional liquid-liquid extraction (LLE) and solid-phase extraction (SPE) procedures. An LC/MS/MS method was developed for the quantitative detection of AAS glucuronides, using a deuterium-labeled steroid glucuronide as the internal standard. LPME, owing to its high specificity, was shown to be better suited than conventional LLE and SPE for the clean-up of urinary AAS glucuronides. The LPME/LC/MS/MS method was fast and reliable, offering acceptable reproducibility and linearity with detection limits in the range 2-20 ng ml(-1) for most of the selected AAS glucuronides. The method was successfully applied to in vitro metabolic studies, and also tested with an authentic forensic urine sample. For a urine matrix the method still has some unsolved problems with specificity, which should be overcome before the method can be reliably used for doping analysis, but still offering additional and complementary data for current GC/MS analyses.     

Printed plastic electronics and paperlike displays

Plastic electronic materials and high‐resolution printing methods may be important technologies for new classes of consumer electronic devices that are lightweight, mechanically flexible and bendable, and that can cover large areas at low cost. This article summarizes some of our recent work in this area. It focuses on the materials and patterning techniques that we used to produce plastic active‐matrix backplane circuits for a type of paperlike display. © 2002 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 40: 3327–3334, 2002     

Solid-Phase Microextraction Gas Chromatography for Determination of Some Organophosphorus Pesticides

A simple and rapid solid-phase microextraction (SPME) method is presented based on activated charcoal–PVC fiber for determination of some organophosphorus pesticides from aqueous samples in direct mode SPME. After optimization of the experimental variables affecting SPME of the target compounds from aqueous solutions, the proposed method was applied to determine pesticides in fruit juice. The analytes in this procedure were preconcentrated for 15 min on the SPME fiber and subsequently desorbed by heating the fiber at 200 °C for 5 min in the GC injection port. Separation was on a capillary column GC followed by flame ionization detection. Recoveries of the pesticides studied in aqueous samples ranged 42%–63% and repeatability for all analytes was < 9% for a single fiber. Fiber-to-fiber reproducibility was < 18%.     

Determination of organochlorine pesticides by gas chromatography with solid-phase microextraction

Summary A study of different extraction techniques for the determination of a selected group of organochlorine compounds in surface waters is presented. Comparison of liquid-liquid extraction (LLE) with solid-phase extraction (SPE) and solid-phase microextraction (SPME) with fibers of different polarity shows that SPME with a recently commercialised fiber of polydimethylsiloxane divinylbenzene allows these compounds to be determined in surface waters with good extraction efficiencies. Extraction time, effect of temperature, ionic strength and pH were optimised, allowing quantification in agricultural effluents in the range 1.0–60 ng·L⁻¹.